socketless fitting liner failure

(1) pipe, and by adding a plasticizer, the hard layer of a soft plastic tube: Rubber rupture. Softener overflow hose overheating. In addition, overheating caused by a large pressure drop of the fluid cylinder, when the valve or other components of the liquid decomposition oxide in the hose, to harden. In this case, you should start the system temperature is normal throttle intake channel is smooth, all close to the high oil temperature and degradation caused you to replace the hose. Shows only the inner casing of the rigid plastic hose breakage at the bottom and a good bit, this is because the fluid hose due to rupture flat excessive bending too fast or reverse phenomenon of heating and accelerating the oxidation, so that the inner hard The rubber layer of the hair. metric hydraulic fittings
(2) significant deterioration, hoses, significant swelling: severe deterioration, significant swelling of the hose to the hose inner tube made of plastic, there is no hydraulic oil, chemical deterioration of the hose. If this happens, check the tank return port found any damage to the rubber sheet. This standard should verify the compatibility and operating temperature of the fluid hose plastic.hydraulic banjo fittings