Studied in order to determine this chapter three types of welding corrugated hose stress distribution along the shaft section, we use a the exported solution of 14. Discussed below two load cases: 1) corrugated hose by stretching of axial force (p = 0; Today.), 2) the end is not moving, the corrugated hose to withstand the pressure and axial force (force equilibrium, potassium p 0; = 0).
I corrugated metric hydraulic fittings in both load conditions, when k = 1.3 and HL h = 10, the relative stress distribution characteristic curve along the shaft section of the diaphragm shown in Figure 56 above. As can be seen from the graph: two load case, are of the bending stress cloud, maximum circumferential direction of the bending stress al distribution similar to the former, but the value is approximately ':. 1/3, the bending stress graph is made in the outer surface of each point. Week to film stress on the flat portion of the diaphragm shaft section cloud: Small; joints close to the diaphragm, it is increased. Having made the film stress at. Than stress 6g. An order of magnitude in the graph have not been indicated.hose adapters
没有评论:
发表评论